Llave para baño de diseño acanalado de una manija en cromado

Hi Kevin Paul Designs, Thank you for your inquiry! The Delta Ara Lavatory 568LF-MPU faucet requires a hole of 1 1/8"-1 1/2" (29-38 mm). https://media.deltafaucet.com/SpecSheet/DSP-L-568LF-MPU%20Rev%20E.pdf Best regards, Tanya

Hi, Yg, Thank you for your question! The lift rod is in the back of the spout assembly for this faucet can be raised straight up from the spout. Best Regards, Rosanna

Hi Jason, Thank you for your question. The cloudy water is the result of air being added to the water. Some turbulence in the waterways is the most likely cause. We recommend completely opening the water stops supplying the faucet. Thanks, Dave

Hello Tcmt, Thank you for your question. Unfortunately, the lift rod on the backside of the Delta Ara Channel Lavatory 568LF-MPU faucet may not be able to connect to the pop-up assembly, if installed in a vessel sink. You make want to install one of our Push Pop-Up Drain Assembly 72174 or 72175. https://www.deltafaucet.com/parts-product-detail?modelNumber=72174 https://www.deltafaucet.com/parts-product-detail?modelNumber=72175 Best regards, Tanya

Hello! Thank you for your question. The hole size for the 568LF-MPU faucet is 1 1/8"-1 1/2". You can find this measurement and more here: https://media.deltafaucet.com/SpecSheet/DSP-L-568LF-MPU%20Rev%20E.pdf Best Regards, Rosanna

Dear Ra89, Thank you for your inquiry! The red and blue indicators on the Delta Ara Lavatory 568LF-MPU faucet can not be removed from the faucet handle. Best regards, Tanya

Hello Nate, Thank you for your question. Yes, the Delta Ara Lavatory 568LF-MPU faucet does come with the metal Pop-Up Assembly RP26533. https://media.deltafaucet.com/PartsDiagram/DPD-L-568LF.pdf Best regards, Tanya

Hi, Rosie 123! Thank you for your question and I am sorry to hear that you are experiencing low flow from your Delta faucet. We do recommend to flush the valve to make sure no debris is causing the low flow. To flush, first turn off the water supply to the faucet.           1. Remove the handle. On the lever handle, you should find a small hex screw that can be loosened with a 3/32" Allen wrench. The handle will lift off when this screw is loose enough.           2. Once the handle has been removed, unscrew the dome-shaped cap. The domed shaped cap will unscrew counter-clockwise.            3. Once the cap has been removed, grasp the round metal stem. The valve cartridge will pull straight out. Also remove the flow restrictor and rinse these parts. You will need to reinstall these parts later, so be sure to note how they are positioned in the valve.      4. Now, with the valve completely disassembled, place a bucket upside down over the top of the empty brass valve body. Turn the hot and cold water supplies back on and let the water run for about 10 to 15 seconds. The water will come directly up out of the valve and should mostly be deflected back into the sink by the bucket. You might have a little bit of water to clean up, though!           5. Shut off the water supplies. Reinstall all parts. If the flow is not better, please contact our Delta Customer Service line at (800)345-3358. We are available Monday-Friday, 7am-7pm, CST and Saturday, 8am-5pm, CST. You may also email at customerservice@deltafaucet.com. Best Regards, Rosanna