Llave para baño independiente de dos manijas en acero inoxidable

Thank you for your question, Jerry! The part number for block and o rings that secure the hose to the copper lines is RP60121. Best Regards, Benjamin

Hi Amanda, Thank you for your question. You may need an adapter to connect the supply lines. The faucet has threaded 1/2"-14 NPSM supply fittings. You can verify whether this faucet will work in your installation by clicking the link below to view the Technical Specifications. http://www.deltafaucet.com/customersupport/documentation/3553lf-rb.html?document=ts&documentIndex=0#flashWrapper Best regards, Jon

Dear R.T., Thank you for your inquiry! The spout and handle bases of the Delta Vero Lavatory 3553LF faucet are 2" (51 mm). https://media.deltafaucet.com/SpecSheet/DSP-L-3553LF%20Rev%20E.pdf Best regards, Tanya

Hi, Stefano. Thank you for your question. The stream straightener for the Delta 3553LF faucet simply pushes straight up into the mouth of the spout to install. Best Regards, Rosanna

Thank you for your question, embiidphila! The placement of the handles will rely on the valve orientation. If the base of the handle is not appropriately placed then the lever will also stop short of center. Please refer to diagram A and B in section 1 of the maintenance and installation manual for instructions. For further assistance, please contact our customer service team directly at 1-800-345-3358 Monday-Friday: 8a.m.-8p.m. EST and Saturday: 9a.m.-6p.m. EST or via email at customerservice@deltafaucet.com. https://media.deltafaucet.com/MandI/86410%20Rev%20C.pdf Best regards, Edward

Hi Dmoench, Thank you for your question. Please refer to diagram B in section 1 of the instructions. Please make sure that the top glide ring (5) is installed with the flat side face up. Please also be sure to press the handle (6) down until it is flush with the handle base (7). Please also make sure that the top retainer (8) is threaded all the way down onto the valve. You may need to loosen the mounting nut to thread the retainer. Installation Instructions: http://www.deltafaucet.com/customersupport/documentation/3553lf.html?document=mi&documentIndex=0#flashWrapper Best regards, Jon

Hi Everett, Thank you for your question. Based on the "Maintenance" section of the below Maintenance/Installation document link, page 4. It states that you can pull out the stream straightener out of the end of the spout, with a long nose plier. This tool would not come in the box with the faucet. https://media.deltafaucet.com/MandI/86410%20Rev%20C.pdf Best regards, Tanya

Hi, Cory! Thank you for your question. Although our finishes are extremely durable, they may be damaged by harsh abrasives or polish. To clean, we recommend simply wiping with a gentle damp cloth and then blotting dry with a soft towel. If water deposits are especially troublesome, you may use a 50/50 mixture of white vinegar and water to remove them. White vinegar is strong enough to dissolve mineral deposits, yet mild enough not to damage our finishes. Note: Please be aware white vinegar may stain some porous materials like untreated stone. If you have an unsealed tile or counter top, please take care when cleaning your products. If you’d prefer using a chemical cleaning product, our finishes may be cleaned with the following household cleaners: Formula 409® Antibacterial All-Purpose Cleaner, Fantastic® All-Purpose Cleaner, or Windex® Original Glass Cleaner, when used according to the manufacturer’ instructions. Any cleaners not listed above may be tried if they do not contain hydrofluoric, hydrochloric and/or phosphoric acids or similar caustic agents. Some examples of chemical cleaners to avoid are: green Scotch-Brite Heavy Duty Scrub Sponges, Scrubbing Bubbles Bathroom Cleaner and Lysol Basin Tub, and Soft Scrub and Tile Cleaner. Note: Any products that state on the label that they remove tarnish and rust will most likely harm the finished products. Most drain cleaners may be used when following their specific directions and not allowing exposure to the finish longer than 30 minutes. Best Regards, Rosanna

Dear JM, Thank you for your inquiry! Yes, the 2 5/8" is the correct distance from the end of the spout to the counter-top/sink, for the Delta Vero Lavatory 3553LF faucet. Best regards, Tanya

Dear Dee, Thank you for your question. The Delta Vero Lavatory 3553LF faucet had a flow rate of 1.5 gpm at 60 PSI in 2012. To comply with all states current plumbing codes and restrictions the flow rate of this Vero faucet converted to 1.2 gpm at 60PSI, starting July 1, 2016. Best regards, Tanya

Hi, Thank you for contacting us. We apologize for any inconvenience. We are more than happy to help you. Please try using a 50/50 white vinegar and water solution. It can be used as a cleaner, then rinse and wipe with a soft cloth. This will help dissolve mineral buildup. Please contact us at 1-800-345-3358 if you have any further concerns. We are open Monday through Friday 7:00 AM to 7:00 PM central time, and 8:00 AM to 5:00 PM on Saturday. Best Regards, Bethany

Hi Jays, Thank you for your question! The 3553LF-CZ lavatory faucet only releases 1.2gpm ( gallons per minute) which would not be enough water to fill a tub in good timing. Best regards, Brandis

HI, CROCHE! Thank you for your question. The Delta 3553LF-CZ Faucet is able to be sent to California as this has a flow rate of 1.20 gpm @ 60 psi. Best Regards, Rosanna

Hi, Danny! Thank you for your question. Unfortunately, the RP10612 Extension kit will not fit the Delta 3553LF faucet. We do apologize for any inconvenience this may cause. Best Regards, Rosanna

Hello, Thank you for your question! These two stem units are interchangeable. The RP24096 will allow the handle to turn a full 180 degrees while the RP25513 (which uses the RP24097 quarter turn stop) only allows the handle to turn 90 degrees to be in the full on position. Please reach out with further questions! Best Regards, Tim Digital Communications Specialist

Thank you for your question. The spout on Delta Faucet model #3553LF has a height of 6 3/8 inches. Included is a link to the spec sheet for visual assistance. http://www.deltafaucet.com/customersupport/documentation/3553lf.html?document=ts&documentIndex=0#flashWrapper

Hi, Velda! Thank you for your question. Cleaning and care techniques can be found here: https://www.deltafaucet.com/design-innovation/inspiredliving/how-to-clean-a-faucet Best Regards, Rosanna

Hi Laura, Thank you for your question! This model has a push pop-up drain assembly. Simply press the stopper to close or open the drain. Best regards, Jon

Hi, Whitten5! Thank you for your question. The Delta 3553LF faucet aerator does not increase or decrease the water flow. The aerator aerates the water to flow in a smooth ribbon. Best Regards, Rosanna

Thank you for your question, richard! The part number for the pop up drain, that is included with model 3553LF-CZ is 33W576CZ. If you need further assistance, feel free to contact us directly. Best Regards, Benjamin

Hello, Thank you for your question! This model utilizes the RP24096 stem units and RP4993 seats and springs. https://media.deltafaucet.com/PartsDiagram/DPD-L-3553LF%20Rev%20E.pdf https://www.deltafaucet.com/parts/product/RP24096.html https://www.deltafaucet.com/parts/product/RP4993.html Please reach out with further questions! Best Regards, Tim Digital Communications Specialist

Hello Greg5200, Thank you for your question. The handle and spout bases of the Delta Vero Lavatory 3553LF faucet are not sold as separate parts. However, the handle bases are included with the handle kits RP63349 (hot) and RP63350 (cold). https://media.deltafaucet.com/PartsDiagram/DPD-L-3553LF_A.pdf Best regards, Tanya

Hi frandrupl, We are sorry that you are experiencing a problem with your faucet. Unfortunately the design of the spout on the model 3553LF does not allow for an aerator or aerated stream. Lowering the water flow is the only way to reduce the splashing. Thanks, Dave

Hi, Sallie! Thank you for your question. The Delta 3553LF Faucet in the Chrome finish will be a shiny, reflective finish. Best Regards, Rosanna

Thank you for your inquiry, Phil W! We recommend a minimum of 2 1/2" (64mm) to the back splash, for the installation of the Delta Olmsted Lavatory 3553LF faucet. Cleaning the faucet may be difficult, if the faucet is installed at a lesser distance to the back splash. Best regards, Tanya

Dear Joe S, Thank you for your question. There are overflow holes in the flange assembly of the Metal Pop-Up Drain assembly 33W576, that comes with your Delta Vero Lavatory 3553LF faucet. The drain assembly will work with your sink installation. Best regards, Tanya

Hi mbgangl, Thank you for your question. The copper supply tube for the spout of the Delta Vero Lavatory 3553LF faucet is designed to move for an easier installation. Best regards, Tanya

Hello Rayr, Thank you for your inquiry! The Delta Vero Lavatory 3553LF faucet can be used on any standard under-mount or top mount sink installation. We do not manufacture or recommended any certain type of sinks or counter-tops, for our faucet installations. Best regards, Tanya

Hi Terri, Thank you for your question about the Delta Faucet model 3553LF-SS Vero® Two Handle Widespread Bathroom Faucet In Stainless. We will be happy to assist you as quickly as possible. Our Stainless finish is a Brilliance finish to resist corrosion, tarnishing, and discoloration. See here for more information: https://www.deltafaucet.com/design-innovation/innovations/kitchen/brilliance-finishes Please contact us directly if you have any questions or need additional assistance. Thank you for being a loyal Delta Faucet customer. We appreciate your business and look forward to continuing to serve you! Best Regards, Bryan Digital Communications Specialist